After the end of the device debugging brick moulding machine production line

Fly ash brick making machine must be finished debugging device that has what you need to debug , how to debug it? Let them know what we a .
First and foremost, adjust the blade and the barrel bottom feeder arrangement gap not more than 2mm, the gap under the barrel feeding arrangement between the underside and the market should not be greater than 0.5mm, feeding arrangement between the ring and the upper barrel adjust the feed tray the gap should be between 0.5-1mm , adjusting track height so that the top of the brick , the mold surface to 1 mm above the disk , adjust the eccentric shaft pressed brick arrangement , it can be pressed out of brick needed.
Secondly , after the Fire brick making machine devices , it is necessary to test, test before the appearance of the machine you want to see , do not tighten the fasteners to eradicate inverted plate appearance, horizontal wells , and other debris on the drive components to be together smooth points each add a little oil , then manually move the machine will reverse the plate inverted for 2-3 weeks until the stop is not stuck appearance , qualified after all to see the experiment can be empty , brick moulding machine operating time is not Less than two hours , to carefully observe the condition of the bearing temperature meshing gears , motor temperature and smooth condition , note pressed brick roof tiles arrangements and track parts of the job situation , after passing empty experiment , gradually adding the volume of feed , perform a load test again to see some operating condition at all under load , the load test of not less than four hours .