Lightweight aerated concrete brick making machine Failure Analysis

The phenomenon of new lightweight aerated concrete brick making machine block body produced during cutting due to mechanical or man-made causes adverse effects or damage caused by defects appear on the quality products, and even become defective waste is often seen, especially in the poor performance of the cutting machinery , poor maintenance performance degradation and lower operating personnel technical level , poor quality consciousness , the case cuts cut bad products even more frequent occurrence . Most of the plant 's production practices proven technical competence and quality of work is good or bad cutting process is an important part of the impact and effectiveness of the rate of qualified products .

Type products affect the cutting process are varied . Impact is also uneven . The reason for these problems is more numerous , varied. This type of cutting equipment , performance related , and the entire production process , but not with the level of production operations related to production management .

Only the domestic common multiple for presentation to the yoke , and only from the mud brick making machine performance and technology both for the necessary analysis to explore in order to achieve a similar problem when handling the reader in the actual production of some useful inspiration.

Common adverse phenomenon cutting process has the following seven major :
1, body fracture ,
2, angular body damage ,
3, body after cutting re- adhesion,
4,Slump occurs when the cutting body 4 ,
5, transported the body in absorbing fall,
6, wire can not be passed body ,
7, Cut size error exceeded.