Manual brick machine equipment after commissioning mission

Manual brick machine must be finished debugging device that has what you need to debug , how to debug it? Let them know what we a .
First and foremost, adjust the blade and the barrel bottom feeder arrangement gap not more than 2mm, the gap under the barrel feeding arrangement between the underside and the market should not be greater than 0.5mm, feeding arrangement between the ring and the upper barrel adjust the feed tray the gap should be between 0.5-1mm , adjusting track height so that the top of the brick , the mold surface to 1 mm above the disk , adjust the eccentric shaft pressed brick arrangement , it can be pressed out of the brick needs ;
Secondly , after the interlocking brick making machine devices , it is necessary to test, test before the appearance of the machine you want to see , do not tighten the fasteners to eradicate inverted plate appearance, horizontal wells , and other debris on the drive components to be together smooth points each add a little oil , then manually move the machine will reverse the plate inverted for 2-3 weeks until the stop is not stuck representation , all view can be empty after passing test , operating time is not less than 2 hours after carefully observing the bearing temperature , gear position and smooth motor temperature conditions, pay attention to the top of the adobe brick making machine parts of the job situation , empty the experimental arrangements and qualified machine track , gradually adding the volume of feed , perform a load test and then view all some operating condition under load , the load test of not less than four hours .